Application of
WOODS™ Exterior Oil Finish

Two applications of tinted WOODS™ Exterior Oil Finish, with one or two applications of WOODS™ Exterior Oil Finish clear. This system will produce a deep oiled looking finish giving the dense grain a smooth sheen.

Supplies
WOODS™ Conditioner WOODS™ Exterior Oil Finish WOODS™ Pigment Pouch Roller or airless sprayer Eye protection	Natural bristle brush Bucket of water Rags Soap and water for cleanup

Staining Tips

• Test a small area for colour (do 2 applications of colour).
• For optimum protection, 2 applications of WOODS™ Exterior Oil Finish tinted and 1 application of WOODS™ Exterior Oil Finish clear.
• Apply stain from one end of a board to the other.
• On vertical surfaces, always work from the bottom up.
• Store unused products in airtight container.
• For siding it is recommended that all four sides and ends be treated with one coat of WOODS™ Exterior Finish.
• Do not dilute any of these products.
• Do not apply in direct sunlight, when wood is hot, when wood is wet, when temperature is below 5° C, or when rain or freezing will occur within 24 hours.
• Do not use WOODS™ products over surfaces that have been cleaned with bleaches, TSP, etc. or coated with other products.

Application

Three Simple Steps

• Step 1 - Prepare
  • The wood surface must be dry and free of dirt, oil, grease, wax, rust, mildew and any other surface contamination. Use the appropriate WOODS™ Exterior Conditioner to prepare your wood for finishing.

   

• Step 2 - Protect
  • WOODS™ Exterior Oil Finish - 3 applications Add one full WOODS™ Pigment Pouch as per directions to WOODS™ Exterior Oil Finish. The first and second applications of finish must contain pigment.
  • Apply a flood coat of WOODS™ Exterior Oil Finish with a brush or roller. Always start from the bottom and work your way up.
  • Back brush as you are applying. This method assures maximum penetration into small cracks and removes runs.
  • Allow a minimum 24 hours of drying time between 1st and 2nd coats. If humidity is high, allow up to one week between coats.
  • A third application of clear WOODS™ Exterior Oil Finish as per the above directions gives optimum protection to the wood.

   

• Step 3 - Preserve
  • Once a year!! Wash the surface with a mild solution of WOODS™ Exterior New Wood Conditioner, then rinse thoroughly with clean water.
  • If water penetrates the surface (allow surface to dry thoroughly) apply a wipe coat of WOODS™ Exterior Oil Finish to restore luster and protection.

Caution: This product will be damages if frozen. Store at temperatures above 5ºC.

THE NATURAL STAIN COMPANY OF CANADA INC. encourages all users of our products to email or call us if you have any application questions and/or problems. No question or problem is too small or too big.

For more information, please download our info kit or call:

1 800 267-8246